Ultimate Motorwerks STOCK K16 car does 7.92 60-130
#20
[and then good luck trying to get the bearing races off. JoeTwinT helped me out a lot with some good advice.[/quote]
If you seperate the axle from the cv and pull most of the ball bearings out and postion the race verticle correctly in the stub you can pop the race out with out any problems no grinding or drilling required. Took but 10 min. for both. This can save alot of time.
If you seperate the axle from the cv and pull most of the ball bearings out and postion the race verticle correctly in the stub you can pop the race out with out any problems no grinding or drilling required. Took but 10 min. for both. This can save alot of time.
#22
Last edited by TXGold; 01-13-2009 at 08:45 AM.
Thread
Thread Starter
Forum
Replies
Last Post
PorscheEnthusiast
Automobiles For Sale
2
11-13-2015 02:23 PM
AJUSA.com
997 Vendor Classifieds
4
10-08-2015 05:50 PM