Z06 vs GT2 (Original, I know:)
#47
07-31-2009, 03:21 PM
Registered User
Join Date: Aug 2005
Location: Melbourne Beach, Fl
Age: 61
Posts: 1,477
Rep Power: 116 
This was the stock dyno on my Gt2. I wanted to use it as a reference to see what I gained after my flash, exhaust and waste gates. I'm not saying that it is accurate, but that's what the numbers were.
#49
07-31-2009, 03:40 PM
I guess i was wrong to doubt the hp on dynojet. They always read higher than mustang and others i am used to.
#51
07-31-2009, 11:09 PM
I'm in anytime...too bad I'm in Texas...not sure if a 40mph roll would be great for the Z06.
At 40mph where are the GT2's in the rpm range and what gear...? The GT2 may pull the Z06 slightly at that speed I'm not sure. 60-70mph roll the Z06 will probably pull slightly.
When it goes into the dreaded 5th in a 'stock' Z06 the GT2 will start pulling away or gaining slowly until the Z06 gets back into its power then the GT2 would stop pulling. Just not sure if a stock Z can reel a GT2 back in if it's ahead at that speed...I'd love to try it though.
At 40mph where are the GT2's in the rpm range and what gear...? The GT2 may pull the Z06 slightly at that speed I'm not sure. 60-70mph roll the Z06 will probably pull slightly.
When it goes into the dreaded 5th in a 'stock' Z06 the GT2 will start pulling away or gaining slowly until the Z06 gets back into its power then the GT2 would stop pulling. Just not sure if a stock Z can reel a GT2 back in if it's ahead at that speed...I'd love to try it though.
Very close to what most stock Z06's dyno. Would be a very good race.
Thread
Thread Starter
Forum
Replies
Last Post
RallyBird
Automobiles For Sale
5
10-07-2015 01:20 PM
turbotuner20v
Automobiles For Sale
20
09-11-2015 12:02 PM
