Anyone knows which vendors sells these kits? 1.2Bar not 1.0Bar.

 

????

 

I would like to know myself

 

What are you trying to achieve? 1 BAR wastegate springs are good till 1.4+ BAR of boost

 

Why do yo want 1.2 bar springs?
turn up your 1 bars and you get the same thing..... the 1.2 bars may be too difficult to dial in... I had them about 4 years ago...
One solution is use a Greddy boost controller... then you can dial it in exactly where you want it...

 

well i'm having a hard time dialing in the EVOMS 1 Bar wastegate kit to achieve 1.4Bar, all i saw is 1.2bar, i thought maybe if i use the 1.2bars, it will reach 1.4bar easily.

 

something is wrong... most guys overboost with the 1 bar springs as is...
I would use a gauge to check if they open up at the same time.... then turn it in clockwise 2 turns... you should not have a problem with that...
stay away from 1.2 bar... when it gets hold you will be boosting .2 bar more...
Some tuners do not use a EBC but its a wonderful thing if you know what to use it...

 

Is it possible the ECU has been tuned to prevent an overboost? It has an e-throttle so that safety could be done I suspect. If they did this for 1.2...... Have you spoken with EVOMS about this?

 

My tuner is EPL, and i think Tony has tuned it to 1.4bars, because sometimes i can see it holding up to 1.3bars in colder days, but i never saw 1.4bar yet, i'm sure its the wastegate kit not the tune, its just a pain to set them up where you want.

 

i think i will check again as Markski said maybe they are not opening up at the same time, both sides are setup at 13.5PSI each.