007-911 gets TA treatment
#16
I had the shop drill holes in the bumper and add leds. I could have put on the stock ones from porsche but they just act as turn signals.
#21
so thats the 997 ta front modified for the 996. and the 997 ta rear and spoiler...i like the rear. prolly would flow a little bit better with the 997 ta sides. but it does look evil!
#23
Thanks guys, yeah the kit is off a 997.2 TA modified for a 996. Its made of fiberglass as is the orignal TA kit. I got the kit made from percision porsche. I am hoping that the 996 led lights are made or else I am going to change the rear fenders to fit the 997.2 taillights.
#24
they sell the 997 quarter panel intakes (where the air for the ic's comes from) for the 996 now too. wicked porsche sells em.
i have heard that its expensive to do the rear tail light conversion. i talked to tony in length about the process and he said it would be cheaper to weld the 997 quarter panels. the line where the bumper meets the quarter panel on the 997 is at an angle towards the top and the 996 is at the bottom of the tail light.
if you did the wicked scoops and the led tail lights for the 996, it would be close. i think the bigger scoop gives the quarter that deep rounded look from the front. but then youd want to do the full front conversion lol...
i have heard that its expensive to do the rear tail light conversion. i talked to tony in length about the process and he said it would be cheaper to weld the 997 quarter panels. the line where the bumper meets the quarter panel on the 997 is at an angle towards the top and the 996 is at the bottom of the tail light.
if you did the wicked scoops and the led tail lights for the 996, it would be close. i think the bigger scoop gives the quarter that deep rounded look from the front. but then youd want to do the full front conversion lol...
Last edited by ixotuckeroxi; 08-05-2011 at 12:40 PM.
Thread
Thread Starter
Forum
Replies
Last Post