I'm looking for a nice clean set...new would be good to. If you have or know someone that does let me know. I know this should be posted over in the parts for sale area but I never go there and I'd imagine many of you guys don"t either.
Anyway...Thanks
JB

 

I have some brand new K24's and some used FVD upgraded K24's (540bhp+). PM me if interested.

 

pm has been sent.

 

get ready for some lag

 

stock ones yes but not hybrids done right....
but then nothing compares to small weak k16s...
its always a trade off... but most guys dont mind a few hundred RPMs of lag for and extra 150 HP.
just my opinion.

 

Marski

What do you think is the best 1/4 that can be achieved with the k16s (along with other mods..ported headers/exhaust/flash)?

 

I never ran it on my stock k16s... but from the ur question I would say 11.9 seconds. there is only so much u can do with 500 hp.
I averaged 11.7 with fvd k24s stage3 and 11.5 best. 1.74 60 ft.

k16s dont produce the power.... u really need a bigger housing like the k24 as a starting point. I think the evoms gt640 or the protmotive k24/18g is the best way to go. both options run on a 5 bar FPR and are the best when u want to keep stock fuel system.

 

What kind of boost and power would be achieved running the k24/18g zero clearance hybrids? What would the estimated 1/4 time be with this set-up assuming a RWD conversion was done?

 

u run 1 bar of boost on pump gas and 1.3 bars of boost on 100 octane. this is controlled via a greddy boost controller so ur wastegates are 100 % controllable- very nice. no throttle body shut down at 1.3 bars either- that written out via the software... another nice feature. it runs low 11s.
these are the saem turbos Scott(divirextreme) has on his 700 hp set up except he has the fuel system ,76mm throttle body, and intercooler upgrade. he ran 10.6 1/4 mile at 135 mph.
to be fair, the evoms gt640 also has the 1.3 bar shutdown bypassed.

 

Ditto that.........Johnny, you really looking to change out for stock 24s?

 

Thanks Markski.

 

pm sent....

 

Well I'm sending the K24 to Todd at protomotive to do the hybrid thing. Bigger wastgate springs...ECU upgrade. I have a Europipe 11 Loud comming...I just got the PSS9 installed...my Iforged 19's....a few little other things...I'm ready to show you guys my ride...finally
JB

 

Damn! Dude! You got it BADDDDDDD..........You just totally gave in didn't you? Your car is gonna be soooooo nice.......have you been talking to Markski offline? He had me this close to upgrading my turbos and software and a couple of other things......I think as soon as my house sells, I will be upgrading again......listen to Markski, he knows what he's talking about.......

Chris

 

Yea...Marski..he's the Devil...HA...No actually he been a great help. Willing to give me alot of info that I believe will save me money in the long run...I'm almost a little afraid of how fast this car will be when its done... I'm excited now.....
JB