996 pic thread
#745
No problems (yet) re: tail lights...
I need to adjust the tips but have put it off because I'll be replacing these soon with Fabspeeds...
[quote=Breakthru;2316847]Fly - car is still looking great. Did you raise it up a tad higher? I thought it was a little more slammed for some reason.
Nope
Thanks John
Last edited by FLY996; 03-25-2009 at 11:58 PM.
#748
Latest updates
I am not really sure where I am going with this car, but I just swapped out the a Taco wing for the GT3 RS wing (good quality one from MASHAW).
There will be a lot of haters because I have a C4s bumper, MKI side Skirts, GT3 RS wing, and replica wheels.
The wing is radical. I prefer the insert wing to the full trunk lid for a few reasons: 1) retains more of the original sheet metal, and 2) retains the grill at the back that I like of the stock cars while still giving me a wing, and 3) it's not like a bi-plane wing.
I have 14mm spacers on the way for the rear since I recently lowered it about 1" with PSS9 (about the only thing about the car that most will approve).
I plan on adding a glossy black "PORSCHE" strip down the sides and perhaps continue the stripe into the rear and front like the original GT3 RS. I am even tempted to add a center stripe of 12" in width.
Flame away.
There will be a lot of haters because I have a C4s bumper, MKI side Skirts, GT3 RS wing, and replica wheels.
The wing is radical. I prefer the insert wing to the full trunk lid for a few reasons: 1) retains more of the original sheet metal, and 2) retains the grill at the back that I like of the stock cars while still giving me a wing, and 3) it's not like a bi-plane wing.
I have 14mm spacers on the way for the rear since I recently lowered it about 1" with PSS9 (about the only thing about the car that most will approve).
I plan on adding a glossy black "PORSCHE" strip down the sides and perhaps continue the stripe into the rear and front like the original GT3 RS. I am even tempted to add a center stripe of 12" in width.
Flame away.
#750
PorschePRH: Your car looks good. I like the look of the C4S bumper in the rear! Haven't seen that one done before. Personally, I don't mind mixing and matching different sections from different aero kits. In the end it's your ride and if you like it, that's all that matters!
However i do think the car could go a little lower!
However i do think the car could go a little lower!