Need help trouble shooting
#1
Need help trouble shooting
Hey guys,
first start of the year and ran into some troubles.
The car started fine at first and I let it idle for a few minutes in the garage to warm it up a little.
Then I hopped in the car to back it out. The car died as soon as I stated rolling.
Now it would turn over and make a puff of start then die right way.
I have to following code:
P0221
p0121
p0321
p0021
p1415
I think it has something to do with the throttle position sensor on the Y pipe.
I took the connector off it and the orange gasket inside was miss aligned (see picture). realigned the gasket and cleaned connectors, still wouldn't run.
Where else should I look at?
Thanks a lot guys! I am really hoping that I can get it sorted out and go for a drive on the weekend.
first start of the year and ran into some troubles.
The car started fine at first and I let it idle for a few minutes in the garage to warm it up a little.
Then I hopped in the car to back it out. The car died as soon as I stated rolling.
Now it would turn over and make a puff of start then die right way.
I have to following code:
P0221
p0121
p0321
p0021
p1415
I think it has something to do with the throttle position sensor on the Y pipe.
I took the connector off it and the orange gasket inside was miss aligned (see picture). realigned the gasket and cleaned connectors, still wouldn't run.
Where else should I look at?
Thanks a lot guys! I am really hoping that I can get it sorted out and go for a drive on the weekend.
Last edited by Abby997TT; 11-26-2014 at 02:02 AM.
#3
Yea, when I put in my RS engine mounts over the winter; I had to remove the Y pipe to access all the bolts. I stuck some paper towels in the throttle body to keep the stuff out, but forgot to take them out when I reinstalled the y pipe. lol
Thread
Thread Starter
Forum
Replies
Last Post
vividracing
991 Turbo
23
10-02-2015 02:23 PM
ModBargains.com
996 Turbo Vendor Classifieds
0
10-01-2015 11:48 AM