Front splitter project
#16
Originally Posted by imcarnuts
Not working for me either - Only getting a small square with an X in center
Any ideas?????
Any ideas?????
http://www.picvault.info/images/5370...ings%20014.jpg
http://www.picvault.info/images/5370...ings%20013.jpg
#20
#25
My introductory pricing is going to be $1295 each .
Seriously, I am going to take a couple of 4'x8' sheets to a shop and have them cut out as many of these as possible. You can trim these to just sit under the lip and act as a protector only, or let it jut out like a splitter. It's like having a front curb feeler. So far, 100+mph and no issues, and no scrapage yet even with the springs
Seriously, I am going to take a couple of 4'x8' sheets to a shop and have them cut out as many of these as possible. You can trim these to just sit under the lip and act as a protector only, or let it jut out like a splitter. It's like having a front curb feeler. So far, 100+mph and no issues, and no scrapage yet even with the springs
#26
Originally Posted by eclou
My introductory pricing is going to be $1295 each .
Seriously, I am going to take a couple of 4'x8' sheets to a shop and have them cut out as many of these as possible. You can trim these to just sit under the lip and act as a protector only, or let it jut out like a splitter. It's like having a front curb feeler. So far, 100+mph and no issues, and no scrapage yet even with the springs
Seriously, I am going to take a couple of 4'x8' sheets to a shop and have them cut out as many of these as possible. You can trim these to just sit under the lip and act as a protector only, or let it jut out like a splitter. It's like having a front curb feeler. So far, 100+mph and no issues, and no scrapage yet even with the springs
Seriously if you going to sell these I'm interested.
Mike
#30
I am in for a couple bucks over for the R&D Put me up for a two sets. It would set off my white lip spoiler very well.
Eclou - you can call the part EclouArt FS Splitter - laser engrave EArt on it and sell it for $500 each - Of course not to the first group of buyers. haha
Let us know when you are done. You will get a check very quickly. Since you already have the design and measurements - why re-invent the wheel.
Eclou - you can call the part EclouArt FS Splitter - laser engrave EArt on it and sell it for $500 each - Of course not to the first group of buyers. haha
Let us know when you are done. You will get a check very quickly. Since you already have the design and measurements - why re-invent the wheel.