Hi guys,
Installed Ver 6 beta and corresponding USB drivers.
Plug cable into OBD 2 port and computer and program will not work.......
"cable not ready"
I run a windows 7 prof 64 bit.....
Any ideas ?

 

Hi 911 Molar,

Connect cable to OBDII port in your car and switch contact on.
Verify that the green LED on the connector is on.
Connect the cable to the USB port on your computer.
Then start the Durametric program.

Hope this helps,
Joris

 

Do you have the latest cable. Older versions like mine, which was one of the original ones, won't work with 6xx and beyond. If you have the older cable version Durametric will sell you the newer cable for $150, you have to send the old cable in first.

 

all sorted.
Turn ignition on twice (2), followed by hazard lights.
plug in and then open durametric.
Prrrrrrrrrrfect