Rear quarter panel removal - access secondaries
#1
Rear quarter panel removal - access secondaries
Any quick information how to remove rear quarter panels to access secondary mufflers ? I want to make sure my PSE is functioning correctly after installing fabspeed X pipe ....
#2
I may be wrong BUT aren't the rear quarter panels on the 997.2 the same as the 997.1's?
They are welded on!
Am I missing something here or did I not understand the question correctly!?
Stacy
They are welded on!
Am I missing something here or did I not understand the question correctly!?
Stacy
Last edited by justatoy; 02-24-2011 at 02:55 PM.
#3
Stacy
i think he means the rear bumper???
Jim
#7
911 Molar, you have to remove the rear bumper cover. Get the shop manual and it will explain the best. It doesn't take too long to do.
Trending Topics
#8
Mike is correct...takes about 8 minutes
take the lights out (screw on the side when u open engine bay) the pivot out to the outside. Unscrew all the screws on the leading edge to the bumper cover. Unscrew the screw in the wheel well lip and pull the cover away from the car while lifting. It kinds sets in a track. This will give u access to what u want 2 c
Jim
take the lights out (screw on the side when u open engine bay) the pivot out to the outside. Unscrew all the screws on the leading edge to the bumper cover. Unscrew the screw in the wheel well lip and pull the cover away from the car while lifting. It kinds sets in a track. This will give u access to what u want 2 c
Jim
Thread
Thread Starter
Forum
Replies
Last Post
eclip5e
Automobiles For Sale
8
04-28-2022 12:38 AM
3WDistributing
Automotive Parts & Accessories For Sale/Wanted
31
10-27-2017 01:26 PM