F/S: McKenzie custom intake valves for 996TT
#1
F/S: McKenzie custom intake valves for 996TT
I have a brand new set of 12 intake valves that I was originally going to have installed on my car. I ended up keeping the stock intake valves, so they are now for sale. For any of you 996TT or 997TT guys that plan on building your motor, these are the perfect addition.
They cost around $900.00 to have made. Will sell for $700.00.
PM if interested. Thanks.
They cost around $900.00 to have made. Will sell for $700.00.
PM if interested. Thanks.
Last edited by Divexxtreme; 04-29-2008 at 06:11 AM.
#2
Scott,
I'm starting my build in a week or so. I'm using GT3076r .82a/r turbos with Proto intake and fuel system. For internals...Pauter rods, ARP studs, and 100mm steel ductile liners. Todd said I should be at 740-750 rwhp. Would I benefit at all doing those intake valves for this level of HP
Thanks
Raudel
I'm starting my build in a week or so. I'm using GT3076r .82a/r turbos with Proto intake and fuel system. For internals...Pauter rods, ARP studs, and 100mm steel ductile liners. Todd said I should be at 740-750 rwhp. Would I benefit at all doing those intake valves for this level of HP
Thanks
Raudel
#3
Scott,
I'm starting my build in a week or so. I'm using GT3076r .82a/r turbos with Proto intake and fuel system. For internals...Pauter rods, ARP studs, and 100mm steel ductile liners. Todd said I should be at 740-750 rwhp. Would I benefit at all doing those intake valves for this level of HP
Thanks
Raudel
I'm starting my build in a week or so. I'm using GT3076r .82a/r turbos with Proto intake and fuel system. For internals...Pauter rods, ARP studs, and 100mm steel ductile liners. Todd said I should be at 740-750 rwhp. Would I benefit at all doing those intake valves for this level of HP
Thanks
Raudel
Raudel,
Yes, you would benefit. The most prevalant advantages that these will give you is the ability to make more power at lower boost levels and increaed (quicker) boost response. You would probably make more power up top as well.
Todd is the one that recommend these for me...but it was after my build was already complete, so it would have been too much work and $$ to go back into my motor to install them. I really wish I had purchased them before I began my build. You can get more info about them from Todd if you'd like.
Last edited by Divexxtreme; 04-29-2008 at 11:02 AM.
Thread
Thread Starter
Forum
Replies
Last Post
eclip5e
Automobiles For Sale
8
04-28-2022 12:38 AM
turbotuner20v
Automobiles For Sale
20
09-11-2015 12:02 PM