Stole the Wifes Cayenne, Going Under the Knife
#31
12-22-2010, 01:45 PM
Wanted to share some of the completed prototype Cold Air Intake photos. Again this intake will fit all Cayenne S and Turbo models 03-10. Everything is made here out of 6061 aluminum and we use very good K&N cone filters with 3D front inlets. The heat shields will be powdercoated in a textured black finish and the intake tubes will be available in textured red or textured black. We have made the intake to have supporting brackets, use our supplied couplers, and with all the trim put back on the car, it is stealth! Dyno coming soon.
#33
12-22-2010, 11:59 PM
From what I remember, the audi s6 LEDs are too long to fit in the grills, no??
#36
12-25-2010, 11:25 AM
Was the car heat soaked on the stock pull to have such a drop at the top end? Looks like it was pulling lots of timing up top before.. Interesting graph.
#37
12-25-2010, 12:28 PM
Registered User
I can't believe your not making these for the 996..the 996 is the most affordable newer P-Car right now...Make em..will for sure sell tons..i'll be first in line 
#38
12-27-2010, 01:54 PM
I prefer it to be as factory as possible.
#39
01-11-2011, 05:57 PM
Well guys, got the intake kits done. Look for special in the Vendor Classified! http://www.vividracing.com/catalog/a...-p-116823.html
#41
01-11-2011, 06:22 PM
I can sell you a universal set and then tell you how to connect it to switch power. The DRL kit is $100.
#44
01-12-2011, 10:07 AM
Physically - Evos are silicone and These are aluminum. I prefer the aluminum look over the evos. I am sure performance will be indistinguishable. Besides that, I am always looking for small production run stuff to keep my C more unique then the next guys.
