Jacking up the front
#1
Jacking up the front
There's no place to jack up the front in one shot without taking the belly pans down and I never seem to break down and buy a lift. So for this truck I fabbed this up so I can easily lift the front, put stands and done....
On this one I used a pin for the middle that fits all my jacks. Made some plates to add on the ends for more surface area. I have a rubber pad that also slides over for protection. Just not in the pics.
On this one I used a pin for the middle that fits all my jacks. Made some plates to add on the ends for more surface area. I have a rubber pad that also slides over for protection. Just not in the pics.
#4
Thanks, I don't think Cayenne owners would be knocking my door down for this. For the DIY'er one might want to whip one up for themselves. Just thought it might help out.
Here is one I did for my TBSS since I had a stiffening plate that was powdercoated gloss black and now had no jack point. I went a little nuts with this truck, 2wd conversion, LS3 oilpan etc...... Anyway this was more universal and could use it on any jack. No center pin.
Here is one I did for my TBSS since I had a stiffening plate that was powdercoated gloss black and now had no jack point. I went a little nuts with this truck, 2wd conversion, LS3 oilpan etc...... Anyway this was more universal and could use it on any jack. No center pin.
Thread
Thread Starter
Forum
Replies
Last Post
PelicanParts.com
997 Vendor Classifieds
0
08-26-2015 04:37 PM
PelicanParts.com
997 Turbo Vendor Classifieds
0
08-26-2015 04:35 PM
PelicanParts.com
GT3/GT2/GT Vendor Classifieds
0
08-26-2015 04:33 PM
PelicanParts.com
991 Turbo Vendor Classifieds
0
08-26-2015 04:32 PM