Removing turbos
#31
Yeah its the same problem that maxgt from ucrain reported ! He couldnt go past 1 bar with upgrated borg wanner turbochargers , so something must be off .Sportchrono enables overboost , so its the same even on sportchrono ? Until now , what did you get spi750kz ?
Last edited by porschecayenne92; 08-10-2016 at 09:13 AM.
#32
Yeah its the same problem that maxgt from ucrain reported ! He couldnt go past 1 bar with upgrated borg wanner turbochargers , so something must be off .Sportchrono enables overboost , so its the same even on sportchrono ? Until now , what did you get spi750kz ?
until now just got 1 bar with lot of stress
#36
With the 20t and spiking to 1 bar for a brief second the car was tuned and hit right at 715 on vivid Mustang dyno. 22 should hit more as long as no slipping and a good tune. Will have it on a dyno soon once the other parts get here
#37
Hello thank you for your replay at another forum
no data yet
disassembled the whole engine checking every piping and wire)))) looking for the leaks
doesnt hold the 1 bar pressure
after puting everything back will tell the info
no data yet
disassembled the whole engine checking every piping and wire)))) looking for the leaks
doesnt hold the 1 bar pressure
after puting everything back will tell the info
#41
So the bigger 84mm gt3 throttlebody works fine ? It fitted the agency y-pipe because of the silicone adaptor ? Did you use it with 20T turbocharger ?
Also for those moment that it lasted , where did you feel the difference in the rpm band ?
Also for those moment that it lasted , where did you feel the difference in the rpm band ?
Last edited by porschecayenne92; 08-25-2016 at 01:56 AM.
#42
The tb bolted right up. I used the carbon pipe for the 20t. Not sure why it split with the 22s saw 1.2 bar just like before. Slot of air flowing thru. Since I made the cold side pipe from the turbo to I'd bigger. Moving mire more air will get a Metal one made or something and then we will be ready to see what the current tune does. I wasn't there but Rob said pulled Hard. Scary fast he said lol
#45
No ,why ? 1 silicone hoses are 100-200$ with couplers. Than ard hace just to fabricate the plenum . You can alwas do it in full aluminium but the space is tight and the movement will make it hit things.